Compex Systems SGX3226 - Manual (Page 25)

Chapter 4 Software Installation
15
4.4 Accessing to web-based Interface
Instead of using Hyper Terminal Program to configure your Compex SGX3226, you
can also use your Internet browser to access to the web-based interface to configure
your switch.
You need to ensure that your TCP/IP protocol has installed and configured.
Configuration will be much simpler, if you decided to obtain IP address dynamically
and use the gateway default IP addresses. Compex SGX3226 comes with a built-in
DHCP server that automatically assigns IP addresses, DNS and Gateway information
to the computers connected in the same network. It has been pre-configured with IP
address and Subnet Mask of 192.168.100.128 and 255.255.255.0 respectively.
An Internet browser would be used to configure Compex SGX3226. The most
commonly used browsers include Netscape Navigator, Netscape Communicator and
Microsoft Internet Explorer browsers as they support frames and Java. We
recommend you to use the Netscape Communicator V4.06 and higher, or Microsoft
Internet Explorer 4.0 and higher.
Start by running your browser on a PC connected onto the same network as Compex
SGX3226. Enter URL Address, http://192.168.100.128.
4.4.1 Login to Web Browser Interface
The following is a list of the various ways for different browsers in
accessing a website. Follow the instructions for the browser that you use.
In Netscape Navigator
1. Select the File menu, go to Open Location and enter the Gateway’s IP
address. This address is set to its factory default as
http://192.168.100.128.
2. Click on the Open button.
In Netscape Communicator
1. Select the File menu, go to Open Page and enter the Gateway’s IP
address. This address is set to its factory default as
http://192.168.100.128.
2. Ensure that the Navigator radio button is selected then click the Open
button.