Compex Systems SGX3226 - Manual (Page 37)

Chapter 5 Web-based Interface Configuration for Compex SGX3226
27
5.5 WAN Config
You are allowed to connect up to 4 modems to your Compex SGX3226. The WAN
type is pre-configured as disabled. Compex SGX3226 supports Static IP, Dynamic IP
and also PPP Over Ethernet (PPPoE).
If you have chosen self-installation when you register for the broadband service, you
should first test the ADSL modem together with the logon account with your PC or
notebook. Ensure that your modem is connected successfully before attempting to run
with Compex SGX3226. For simplicity and the purpose of illustrations, it is assumed
that LAN uses the IP address 192.168.100.xxx and Compex SGX3226 is using the
same settings as defaults.
However, if you have assigned a different IP address for Compex SGX3226, then use
the new settings in the setup procedures.
Figure 5.1 Default setting of Compex SGX3226 for WAN Setup
WAN Port
You may configure any 4 of the 24 ports as WAN port and connect to your
ADSL/Cable modem.
WAN Type
Static IP Address:
Select this WAN type if you have subscribed to a specific IP address or to a fixed
range of IP addresses from your ISP.
Dynamic IP Address:
This IP address is automatically assigned by your ISP. This type of connection
applies to most Cable Internet subscribers such as:
• Singapore Cable Vision subscribers.
• @HOME Cable Service users.