Compex Systems SGX3226 - Manual (Page 34)

Chapter 5 Web-based Interface Configuration for Compex SGX3226
24
DHCP Start IP Address & DHCP
End IP Address
These parameters specify the range of
the IP address of which the DHCP
Server will assign.
Primary DNS IP Address & Secondary
DNS IP Address
DNS is an Internet service that translates
domain names into IP addresses. If your
WAN connection is using Static IP, you
should configure the primary and
secondary DNS IP addresses with the
DNS information provided by your
Broadband Internet Service Provider. For
other WAN connection types, the DNS IP
addresses is obtained automatically from
ISP. The “Always use these DNS
servers:” checkbox can be used to disable
the automatic process, and your preferred
DNS IP addresses can be used.
DHCP Server
DHCP server dynamically assigns IP addresses to the PCs connected in the same
network. DHCP comes with a built-in DHCP server that automatically assigns IP
addresses, DNS and Gateway information to the computers connected in the same
network. It has been pre-configured with IP address and Subnet Mask of
192.168.100.128 and 255.255.255.0 respectively.
1. Enter the values for IP Address, Subnet Mask, DHCP Start and End IP Addresses
in its individual fields.
2. You can check on Always use these DNS servers: to disable the function of
retrieving DNS IP Address automatically, so that you can enter your preferred
DNS IP Address in the Primary and Secondary DNS IP Address field.
3. Next, you can set DHCP Server to Enable if you wish to use the built-in DHCP
server of Compex SGX3226.
4. Click on Save button to save your configuration.
NOTE
If your IP Address of the PC has set to “Obtain an IP address automatically”,
values in the fields will automatically appeared.