Compex Systems SGX3226 - Manual (Page 46)

Chapter 6 Configuring Your Wide Area Network
36
6.3 Configuring Static IP Connection
1. Select WAN Config from the Command window.
2. Go to WAN Type and select
Static IP Address.
3. Enter the IP addresses in its
respective field. All these
information is provided by your
ISP/Network Administrator.
4. Click on Save button to update the
changes.
6.4 Configuring Dynamic IP Connection
If you are using Cable Internet, you do not need to configure the WAN connection.
However, if your account requires a DHCP Client ID in order to released an IP
address, you may need to configure the name of Compex SGX3226 with the DHCP
Client ID issued by your ISP.
Refer to Section 8.3 on “System Configuration” on Page 61, and remember to enter
the DHCP Client ID issued by the ISP into the System Name field in the System
Identity.
NOTE
If your computer is not able to resolve any web site, please verify that your DNS
entry of the computer has been defined correctly.
As mentioned before, this WAN type applies to most Cable Internet subscribers, such
as Singapore Cable Vision subscribers and @HOME Cable Service users. The
following section will elaborate on the configuration for these two types of services.