Compex Systems SGX3226 - Manual (Page 60)

Chapter 7 Advanced Configuration for Compex SGX3226
50
may name your switch for identification. Refer to Section 8.3 “System
Configuration” for details.
2. Next, disconnect one end of the Ethernet cable from SGX3226 Unit #1
and establish a link to Unit #2. Please refer to Figure 7.2.
3. Go the MS DOS Prompt and enter this command:
arp –d 192.168.100.128.
This will delete the ARP cache so that you can access to Compex
SGX3226 successfully. Please note that adding the IP address in the
ARP command allows system to delete the ARP cache which is
belonged to that particular device.
4. Enter http://192.168.100.128 in the internet browser to select Slave
option in the field provided. Give a name to your switch.
NOTE
You may also use the console port to activate the stacking function of all
switches. We are using 3 switches in this example, therefore, please repeat the
procedures of Steps 1 and 2 for SGX3226 Unit #3. Select Slave option in the
Stacking State field.
Figure 7.2 Establish a connection to SGX3226 Unit #2
5. After selecting the options for individual switches, use RJ45 Ethernet
MDI straight cables to connect all three switches as shown in Figure
7.1 and power up all switches.
SGX3226 Unit #2 (Slave)
192.168.100.128
SGX3226 Unit #1(Master)
192.168.100.128