CITIZEN CT-S300 - Manual (Page 102)

— 97 —
(nL + nH × 256) Printing Speed
1 Printing speed level 1 (84%)
2 Printing speed level 2 (86%)
3 Printing speed level 3 (88%)
4 Printing speed level 4 (90%)
5 Printing speed level 5 (92%)
6 Printing speed level 6 (94%)
7 Printing speed level 7 (96%)
8 Printing speed level 8 (98%)
9 (Default) Printing speed level 9 (100%)
• a = 97: Sets the number of divisions for conducting head specified by (nL + nH ×
256).
(nL + nH
× 256)
No. of Divisions for Conducting Head
2 (Default) 2-division conducting
4 4-division conducting
• a = 116: Sets the paper specified by (nL + nH
× 256).
(nL + nH
× 256)
Paper
1 (Default) Specified single color paper.
257 Recommended 2-color paper5
• a = 6: Sets printing speed to the value specified by (nL + nH × 256).
• a = 201: Outputs ACK to the position specified by (nL + nH × 256).
(nL + nH
× 256)
ACK Output Position
1 (Default) ACK-in-Busy
2 ACK-while-Busy
3 ACK-after-Busy
• a = 202: Controls input buffer full Busy with the value selected by (nL + nH × 256)
and controls Busy with output/cancel timing (remaining capacity).
When Input Buffer Capacity When Input Buffer Capacity
(nL + nH × 256) “Small” is Set 4K Bytes (Large) is Set
Output Cancel Output Cancel
1 16 26 128 256
2 16 40 128 512
3 30 50 72 256
4 30 60 72 512
• XON/XOFF is also output by the establishment of conditions.
• Ignores the data received when input buffer idle capacity is 0.
• This function operates only in printer function setting mode.
• The value changed by this command is enabled by the following.
• Execution of function 2 (fn = 2: End of printer function setting mode) (Recommended)
• Reentering power supply.
• Hardware resetting by reset terminal