CITIZEN CT-S300 - Manual (Page 34)

— 29 —
GS B n
[Function] Specifying/canceling the black/white inverted printing
[Code] <1D>H<42>H<n>
[Range] 0 n 255
[Outline] This command specifies or cancels the black/white inverted printing.
• “n” is valid only for the lowest bit (n0).
• Control by the lowest bit (n0) is shown as follows:
n0 Function
0 The black/white inverted printing is canceled.
1 The black/white inverted printing is specified.
[Caution] • The black/white inversion works on internal and downloaded characters.
• The black/white inversion works also on the right spacing of characters defined by
ESC SP.
• This command does not affect the bit image, downloaded bit image, bar code, HRI
characters, or the skip area specified by HT, ESC $, or ESC \.
• This command does not affect the space between lines.
• Black/white inversion specification takes precedence over underline specification.
Underline printing specified is, therefore, nullified if black/white inversion is
specified; the underline setting, however, remains unchanged.
[Default] n = 0