CITIZEN CT-S300 - Manual (Page 42)

— 37 —
ESC a n
[Function] Aligning the characters
[Code] <1B>H<61>H<n>
[Range] 0 n 2
48 n 50
[Outline] All the printed data within one line are aligned in the specified position.
Depending on the value “n”, positional alignment is carried out as shown in the
table below:
[Caution] • This command is valid only when it is inputted at the beginning of a line.
• This command does not affect the PAGE MODE.
• Executes justification in the print area being set.
[Default] n = 0
[Sample Program]
LPRINT CHR$(&H1B);"a";CHR$(0);
LPRINT "AAAAA";CHR$(&HA);
LPRINT CHR$(&H1B);"a";CHR$(1);
LPRINT "AAAAA";CHR$(&HA);
LPRINT CHR$(&H1B);"a";CHR$(2);
LPRINT "AAAAA";CHR$(&HA);
[Print Results]
n Position
0, 48 Left end alignment
1, 49 Centering
2, 50 Right end alignment
Paper feed direction
Left-justified Centered Right-justified
AAAAA
AAAAA
AAAAA
<