CITIZEN CT-S300 User Manual
Page 46
— 41 —
(2) If a sufficient area cannot be provided as a result of step (1), the print area is
extended toward the left (so, the left margin is decreased).
(3) If a sufficient area cannot be provided as a result of step (2), the right spacing is
trimmed.
• When mapping a bit image (or downloaded bit image), if the print area is narrower
than the minimum width of the bit image (two dots for single density, or one dot
for double density), only the line for that image is handled as follows:
(1) The print area is extended toward the left (so, the left margin is decreased)
until it is equal to the minimum width of the image, but not wider than the
printable area.
[Default]
When paper width is 80 mm: nL = 64, nH = 2
When paper width is 58 mm: nL = 128, nH = 1
[See Also]
GS L, GS P
(1) Extended
toward the right
Printable area
Left margin
Print area width
A
(2) The left margin
is trimmed