Toa C-CC774 PL - Manual (Page 35)

35
6.6. Setting the AGC
The automatic gain controller (AGC) can be set to “AUTO,” “OFF,” or “MAX.” (Factory default: Auto)
AUTO: Automatically adjusts the gain depending on the subject’s brightness level.
OFF:
Disables the automatic gain control function.
MAX: Used when the subject brightness is insufficient when in AUTO mode.
Note
Operation in “MAX” mode may cause excessive vertical noise, however this is not a failure. If it becomes
annoying, select “AUTO” mode.
1. With the joystick, select “AGC” on the Camera Setting screen,
then press the Set key.
The arrow
moves to “AUTO” (factory default).
2. Select “AUTO,” “OFF,” or “MAX” with the joystick, then press
the Set key.
The AGC setting is recorded.
( )
AGC setting screen
- - - - - -
- * - - - - - -
*
* C A M E R A S E T T I N G *
W H I T E B A L A N C E
B A C K L I G H T
D A Y / N I G H T
A U T O F O C U S
A G C
S L O W S H U T T E R
S H U T T E R S P E E D
N E X T P A G E
B R I G H T N E S S
A T W
R B
O F F
N O R M A L
O N E P U S H
A U T O
X 3 2
N O R M A L
-
- - - - - -
- * - - - - - -
*
* C A M E R A S E T T I N G *
W H I T E B A L A N C E
B A C K L I G H T
D A Y / N I G H T
A U T O F O C U S
A G C
S L O W S H U T T E R
S H U T T E R S P E E D
N E X T P A G E
B R I G H T N E S S
A T W
R B
O F F
N O R M A L
O N E P U S H
A U T O
X 3 2
N O R M A L
-
Auto focus setting screen
6.5. Setting the Auto Focus
There are 3 auto-focus modes: “ONE PUSH,” “STOP AF,” and “CONTINUOUS” modes.
(Factory default: ONE PUSH)
ONE PUSH: Auto focusing is operated when the Auto-focus key is pressed.
STOP AF: Auto focusing is automatically operated after the camera scene or angle of view has been
changed. The STOP AF function does not work when the Focus key is used. Pressing the
Auto-focus key again will put the camera in the STOP AF mode.
CONTINUOUS:The Auto-focus function is always operated. However, it cannot be used after preset playback
(including Home Position). In this event, the Auto-focus function can be used through manual
operations. Also, the Auto-focus function cannot be used if the Auto-focus key is pressed, and
can be used if the Auto-focus key is pressed again.
Notes
• Use “ONE PUSH” mode in normal operations. The use of “STOP AF” or “CONTINUOUS” mode may shorten
the life of lens.
• In the following cases, the subject may not be brought into focus using the Auto-focus function.
•
When part of the subject shines brightly.
•
When the distant and near subjects exist together.
•
When the camera shoots a blind or other subject with horizontal stripes.
•
When the subject’s lighting conditions are poor.
•
When the camera rotates at high speed.
1. With the joystick, select “AUTO FOCUS” on the Camera
Setting screen, then press the Set key.
The arrow
moves over “ONE PUSH” (factory default).
2. Select “ONE PUSH,” “STOP AF,” or “CONTINUOUS” with the
joystick, then press the Set key.
The selected content is recorded.
( )