Toa C-CC774 PL - Manual (Page 59)

59
9.2. AUX2 Setting (C-CC564 and C-CC574 only)
The AUX2 is a relay type contact. The controller’s defroster switch is used to control it.
1. Select “AUX2” on the AUX (Contact Output Setting) screen,
then press the Set key.
2. Do not change setting of “Type” on the AUX2 Setting screen.
Note
Do not set types other than Momentary (factory default). If
changed, AUX2 does not operate correctly.
3. Select “ON TIME” in the AUX2 Setting screen, then press the
Set key.
4. Select “NO LIMIT,” “1sec,” “2sec,” “3sec,” “5sec,” “10sec,”
“20sec,”or “30sec” with the joystick, then press the Set key to
set the duration that the contact is maintained ON.
NO LIMIT:
Maintained to be ON until it is turned OFF
“1sec,” “2sec,” “3sec,” “5sec,” “10sec,” “20sec,” “30sec”:
Contact is maintained ON for the preset duration after receipt
of ON instruction.
* A U X *
- - - - - - - - - - - - - - - - - - - - - - - - - - -
A U X 1
A U X 2
AUX setting screen
* A U X *
A U X 2
- - - - - - - - - - - - - - - - - - - - - - - - - - -
T Y P E
O N T I M E
M O M E N T A R Y
N O L I M I T
AUX 2 setting screen