Toa C-CC774 PL - Manual (Page 46)

46
7.5. Setting the Trace Pause Time 1 and 2
When continuously playing back the trace operations with the Auto key (or Auto-Pan key), the stop duration
interval between start position and end position of one trace operations can be set. (Factory default: 1s)
1. On the Auto Operation Setting screen, select “TRACE1
PAUSE TIME” or “TRACE2 PAUSE TIME” with the joystick,
then press the Set key.
2. Select “1sec,” “2sec,” “3sec,” “5sec,” “10sec,” “20sec,” or
“30sec” with the joystick, then press the Set key.
The Trace pause time is recorded.
Auto operation setting screen
A U T O K E Y
T R A C E
S E Q U E N C E
* A U T O M O D E *
T O U R
A U T O P A N
T R A C E 1 P A U S E T I M E
T R A C E 2 P A U S E T I M E
T R A C E 1
1 s e c
1 s e c
A U T O P A N
Trace playback memory screen
T R A C E 1
R E P L A Y
M E M O R Y
4. Press the Set key on Trace Setting in progress screen.
“REPLAY” and “MEMORY” screen is displayed.
4-1 When “REPLAY” is selected
Confirms the stored trace.
4-2 When “MEMORY” is selected
Sets the trace function.
Note
Trace can be set after above Step 4 – 2 procedure has been
performed on trace playback and memory screens.
[ Deleting the trace operation memory ]
Select “CLEAR1” or “CLEAR2” in the same way as “Trace Function setting” Step 3 ( p. 45 ) to delete each
corresponding trace operation.
[ Storing the trace operation over again ]
Follow Step 1 – 4 again after deleting the trace operation in the above way.
Notes
• The stored trace operation may slightly differ from the actual played back image on the monitor. To avoid
this, select a wider angle of view than you wish, and slowly operate camera movements during the trace
operation memory.
• To ensure the reproduction performance, the manual operation speed is limited during trace operation.