Toa VS-900 - Manual (Page 36)

3-8
CHAPTER 3. CONVENIENT FUNCTIONS
4. TIME-BASED CALL FORWARDING
4.1. Function
All incoming calls to the original station* (forwarding station) can be automatically rerouted to the designated
master station* (receiving station) during a specific period of the day.
* Both the forwarding and receiving stations must be either master stations or telephones. Calls cannot be
forwarded to a substation. (See the figure in section 4.3. on the next page.)
[System pre-programming]
(1) To use this function, the Time-Based Call Forwarding function must be enabled in system programming.
(2) The forwarding interval (start and end times) can be registered in the system programming. (Registration
can only be performed for an entire exchange. Different times cannot be set for different stations on the
same exchange.)
4.2. Registration and Cancellation
Use the original station to register or cancel this function.
4.2.1. Registration
First dial [ ][6][3], and then the receiving station number (example: [9][3]) followed by [#].
Registration completion is indicated by a confirmation tone.
[If the current time is in the transfer interval]
The registered receiving station number* is then displayed on the original station's display panel to indicate
that the original station is in Time-Based Call Forwarding mode.
* The name of the station may be displayed.
[If the current time is not in the transfer interval]
The current time is displayed and the station returns to standby mode.
4.2.2. Cancellation
First dial [ ][6][3], and then the original station number (example: [9][2]) followed by [#].
Cancellation completion is indicated by a confirmation tone. The display panel then displays the current time
and the station returns to standby mode.
FWD : 9 3
Displays Time-Based Call Forwarding mode.
Display panel
1 1 : 5 9 am
FWD : O f f i c e 1
1 1 : 5 9 am