Toa VS-900 - Manual (Page 68)

5-2
CHAPTER 5. PC-CONTROLLED FUNCTIONS
Contents Setting Item
"Time-Based Call Forwarding"
Receiving Station* Sets the master station number or an outside line access number to
receive calls automatically forwarded while the system is in Time-
Based Call Forwarding mode. The station numbers connected to all
exchanges can be programmed. The outside line access number must
be identical to the number assigned to the corresponding exchange.
It is also possible not to designate any receiving station.
"Busy Call Forwarding" Receiving
Station* Sets the master station number or an outside line access number to
receive calls automatically forwarded while the system is in Busy Call
Forwarding mode. The station numbers connected to all exchanges
can be programmed. The outside line access number must be
identical to the number assigned to the corresponding exchange.
It is also possible not to designate any receiving station.
"No-Answer Call Forwarding"
Receiving Station* Sets the master station number or an outside line access number to
receive calls automatically forwarded while the system is in No-Answer
Call Forwarding mode. The station numbers connected to all
exchanges can be programmed. The outside line access number must
be identical to the number assigned to the corresponding exchange.
It is also possible not to designate any receiving station.
(2) Substation setting
Registers the following contents designating the exchange number (1 – 16 or ALL).
Contents Setting Item
Station Number Sets the station number within the range beginning at the selected
exchange's first designated station number and ending at the number
immediately preceding the next exchange's first station number. (Refer
to the "System Setting.")
Station Name A name of up to 8 alphanumeric characters can be entered.
Called Station Exchange Number Sets the exchange number to which the called master station/telephone
is connected.
Called Station Line Number Sets the called master station/telephone line number.
Called Station Number Sets the called master station/telephone number.
Called Station Name Sets the called master station/telephone name.
Call Priority Selects the call priority level: Normal or Emergency.
(3) Outside line setting
Registers the following contents designating the exchange number (1 – 16).
Contents Setting Item
Outside Line Name Sets the name of the line.
Outside Line Connection Time-Out Enables/Disables the Outside Line Connection Time-Out function.
Sets a time limit for telephone conversations (1 – 99 minutes).
Outgoing Call Access Number Sets the access number for outgoing calls on the external line (0 – 9).
Note that this setting is invalid for those stations designated as
"receiving-only."
Direct-In Dialing Selects this service.
Direct-In Line Selects this service.
Receiving Station When using the Direct-In line service, a receiving station group
consisting of a representative station and 1 to 3 member stations is set.
To set the stations, both the exchange and line numbers are
designated for each master station (telephone).
* This setting can be performed at the master station as well. Refer to the section describing each call
forwarding function.