Toa VS-900 - Manual (Page 69)

5-3
CHAPTER 5. PC-CONTROLLED FUNCTIONS
2.3. Function Setting
(1) Group call setting
Registers the following contents designating the representative master station/telephone.
Contents Setting Item
Member Station Exchange Number
Member Station line Number
Sets the exchange number (1 – 16) of the master station or telephone.
Sets the Line number (1 – 4) of the master station (telephone).
(2) Call forwarding & time-out settings
Registers the following contents designating the exchange number (1 – 16).
Contents Setting Item
Call Forwarding Enable/Disables the Call Forwarding function.
Time-Based Call Forwarding Enables/Disables the Time-Based Call Forwarding function by its start
and end times.
Time-Based Call Forwarding Start
Time Sets the hour and minute the call forwarding interval will begin. ( 00:00
– 23:59)
Time-Based Call Forwarding End
Time Sets the hour and minute the call forwarding interval will end. ( 00:00 –
23:59)
Busy Call Forwarding Enables/Disables the Busy Call Forwarding function.
No-Answer Call forwarding Enables/Disables the No-Answer Call forwarding function. If enabled,
calls are transferred when no response is detected within the preset
interval.
Sets the station calling interval (1 – 99 seconds).
Call Time-Out Enables/Disables the call time-out function. If enabled, calls are
terminated when no response is made within the preset interval.
Sets the station calling interval (1 – 99 minutes).
Conversation Time-Out Enables/Disables the Conversation Time-Out function. If enabled,
conversations are automatically terminated when the time limit is
reached.
Sets the conversation time limit (10 – 990 seconds).
(3) Scan monitor setting
Registers the following contents designating the master station.
Contents Setting Item
Monitoring Time Sets the scan-monitor time interval (1 – 99 seconds).
Monitoring Substation Exchange
Number Sets the number of the exchange to which the substation is connected
(1 – 16).
Monitoring Substation Line Number Sets the substation equipment number (1 – 64).
Monitoring Substation Number Sets the substation number.
Monitoring Substation Name Sets the substation name.
(4) Paging setting
Registers the substations assigned to the zone designating the exchange number (1 – 16).
Contents Setting Item
Zone Number Digit Selects the length of the digit to be used to label the paging zone
numbers (1 – 2).
Paging Time-Out Enables/Disables the Paging Time-Out function.
Zone Resisters substation numbers (1 – 1024) for each zone.
Sets a Paging time limit (10 – 990 seconds).