Toa VS-900 - Manual (Page 54)

3-26
CHAPTER 3. CONVENIENT FUNCTIONS
21. OUTSIDE LINE NO-ANSWER CALL FORWARDING
21.1. Function
Calls to the original station (forwarding station) are automatically rerouted to the designated receiving
telephone if the called party does not respond within a preset period of time. (See the figure in section 21.3.
on the next page.)
[System pre-programming]
(1) To use this function, the Outside Line No-Answer Call Forwarding function must be enabled in system
programming.
(2) Register a variable "no-response" time of 1 – 99 seconds (in 1 second units) in the system programming.
(Registration can only be performed for an entire exchange. Different times cannot be set for different
stations on the same exchange.)
(3) The receiving telephone number can individually be registered for each master station (or telephone) in the
system programming.
21.2. Registration and Cancellation
Use the original station to register or cancel this function.
21.2.1. Registration
First dial [ ][6][4], and then the outside line access number (example: [0]) followed by [#].
Registration completion is indicated by a confirmation tone. The current time is then displayed, and the station
is placed in standby mode.
21.2.2. Cancellation
First dial [ ][6][4], and then the original station number (example: [9][2]) followed by [#].
Cancellation completion is indicated by a confirmation tone. The current time is then displayed and the station
is placed in standby mode.
1 1 : 5 9 am