Chaparral FS2620R - Manual (Page 20)

FS2620R Rack Model User’s Guide
2-4
!
RS-232 serial port—for configuration and management of the router.
!
Ethernet (10BaseT)—connects to your local area network (LAN) to permit
configuration and management of the router.
For first time installation, attach the SCSI devices first to ensure the router and its assigned
devices are working properly. You should connect all SCSI devices to the router and
power them on. Then power the router on. After proper operation is established, you can
proceed to connect the FC host and the RS-232 or Ethernet ports.
Figure 2-3. Rear panel components
Connecting to the SCSI Channels
With the FS2620R, you can attach SCSI storage devices to up to six of the router’s SCSI
channels. Up to 15 SCSI devices can be attached to each channel (63 devices + router
LUN = 64 LUNs visible to the host system).
The FS2620R is available with Ultra3 LVD SCSI interface. You must use LVD-qualified
SCSI cables.
LVD/SE (wide, Ultra-160 SCSI),
68-pin SCSI (LVD/SE model)
HVD symbol
!
Caution: Do not use with HVD devices with the symbol shown below.
SCSI LVD/SE
SCSI DIFF