Chaparral FS2620R - Manual (Page 63)

Displaying Router Information
3-33
FC Speed 1G
2G
Auto
GBIC
receive
status Signal present—FC is up and
running
No signal—FC is not up and
running
Node
WWN FC World Wide Name for
node.
Port WWN FC World Wide Name for
port.
Loop ID, if
the
topology is
LOOP. SOFT or a specific number
as set in the Router
Administrator software. Current
Loop
ID/Loop
Inactive Currently
assigned value if
the topology is
LOOP, or
Inactive if the
FC link is not
active.
FC Addr 24-bit FC address or None if
the FC link is not active. AL_PA, if
the
topology is
LOOP. Currently
assigned value
or None if the
FC link is not
active.
Router
LUN SOFT, NONE, or specific
number as set in the Router
Administrator software. Current Currently
assigned value
or Inactive if the
Router LUN is
set to NONE.
CHAN 0-5 Initiator ID SCSI ID of router on each
channel as set in the Router
Administrator software. Bus Speed Hardware runs
as Ultra3 160
MB/sec
Domain
Validation Enabled or Disabled
ROUTER Alarm ENABLED or DISABLED
as set in the Router
Administrator software. Scan Delay Number of
seconds the
router waits to
the scan the bus
as set in the
Router
Administrator
software.
Table 3-5. Configuration information (Continued)
Group Field What displays Field What displays