Chaparral FS2620R - Manual (Page 75)

Device SCSI Channel Problems
4-5
Device SCSI Channel Problems
Problem: Not all drives connected to the router device channels are displayed during
boot, or the router hangs during display of connected drives and never reaches the Router
Administrator screen.
Solution: Check your JBOD or tape library documentation to be sure that the device is
properly configured. If your device supports removable drives, check the drive shuttles to
be sure that the power connectors, SCSI connectors, and SCSI cables are properly seated.
Check termination and SCSI ID assignment.
Router is Not Responding
Problem: The router is turned on and connected, but is not working properly and its LED
lights are not lit.
Solution: Replace the fuse.
1 Insert a small flat-blade screwdriver under the tab where the fuse is located and pull
out the fuse and fuse box.
See Figure 2-3 on page 2-4 .
2 Remove the spare fuse from the box and replace the old fuse.
3 Reinstall the fuse and fuse box.
Note: Be sure to use an F2H, 250V fuse.