Chaparral FS2620R - Manual (Page 23)

Powering Up All Devices
2-7
Connecting to the Ethernet Port
You use the Ethernet (10BaseT) port to configure and manage the FS2620R. You use this
configuration option when you need to manage the FS2620R from a remote computer that
is connected to your LAN. For more information about the configuration and management
capabilities, see
Accessing the Router Administrator Using the Ethernet Port on page 3-3 .
To connect to the Ethernet port:
1 Be sure the FS2620R is turned off.
2 Connect one end of the Ethernet cable to the Ethernet port on the FS2620R.
3 Connect the other end of the Ethernet cable to a network hub, router, or other
network connection.
Powering Up All Devices
After you have made all of the SCSI, Ethernet, and RS-232 connections, you are ready to
power up the router and all devices connected to it. For best results, use a two-stage setup
procedure. First, connect all SCSI devices and the RS-232 port to ensure proper operation.
Second, connect the FC host port and finish installation.
To power up SCSI devices:
1 Be sure the router is turned off.
2 Attach the power cable to the back of the router.
See Figure 2-3 on page 2-4 .
3 Plug the power cable into a power source.
4 Connect the SCSI devices to the router using the appropriate SCSI cables.
5 Power up the connected SCSI storage devices and allow them to come ready.
6 Power up the router and allow it to come ready.
The ST status light stays a steady yellow. See Understanding the LED Status Lights
on page 2-8 .
The router recognizes all SCSI devices connected to the six SCSI channels on the
FS2620R, and assigns each device a unique LUN address, which will be mapped as part of
a unique FC address. You can configure the router to assign itself a LUN for in-band
management, server-free backup, and other uses.
!
Caution: Do not remove the router’s cover. The router has no user-
serviceable parts. Removing the cover will void the warranty.