Canon C3200 - Manual (Page 57)

Placing Originals 1-40
Introduction to Sending Functions
1
Feeder (DADF-K1) (Optional)
You should use the feeder when you want to scan several originals at the same
time. Place the originals in the feeder and press
(Start). The machine
automatically feeds the originals onto the platen glass and scans them into
memory. Two-sided originals can also be automatically turned over and scanned as
two-sided documents.
You can place the following originals in the feeder's original supply tray:
• Weight: 14 to 28 lb bond (52 to 105 g/m
2
)
• Size: 11" x 17", LGL, LTR, LTRR, or STMT
• Tray Capacity:
- 11" x 17", LGL: 15 sheets (20 lb bond (80 g/m
2
))
- LTR or STMT: 30 sheets (20 lb bond (80 g/m
2
))
IMPORTANT
• Do not place the following types of originals in the feeder:
- Originals with tears or large binding holes
- Severely curled originals or originals with sharp folds
- Clipped or stapled originals
- Carbon backed paper or other originals which might not feed smoothly
- Transparencies and other highly transparent originals
• If the same original is fed through the feeder repeatedly, the original may fold or become
creased, and make feeding impossible. Limit repeated feeding to a maximum of 30 times.
(This number varies, depending on the type and quality of the original.)
• If the feeder rollers are dirty from scanning originals written in pencil, perform the feeder
cleaning procedure. (See Chapter 7, "Routine Maintenance," in the Reference Guide.)
• Always smooth out any folds in your originals before placing them in the feeder.
1
Adjust the slide guides to fit the size of your originals.