Aiwa XR-MT1000 - Manual (Page 16)

PLAY WITH DOLBY PRO LOGIC ADDITIONAL DOLBY PRO LOGIC MODES
■MANUAL
SELECT
2
1
I DOWN,
►UP
1 Press VIDEO/AUX/5.1 CH and start playback of the
video source.
“VIDEO” is displayed.
If “5.1 ch IN” is displayed, press VIDEO/AUX/5.1 CH again.
2 Press DOLBY PRO LOGIC.
“NORMAL” is selected, and the playback sound has the
DOLBY PRO LOGIC effect.
To cancel Dolby Pro Logic mode
Press DOLBY PRO LOGIC repeatedly until “PRO OFF” is
displayed.
To change the sound levels during playback
After adjusting the balance with the noise sequencer, the sound
levels of the center or each surround speaker can be adjusted
during playback of laser discs or video software.
1
Press MANUAL SELECT (TEST) on the remote control
repeatedly to select “CEN” (center speaker) “S-L” (Left
surround speaker) or “S-R” (Right surround speaker).
2 While the “CEN” “S-L” or “S-R” is displayed, press ◄◄ DOWN
or ►► UP button on the remote control to adjust the volume.
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 STEREO (3CH LOGIC) modes.
PHANTOM mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 STEREO (3CH LOGIC) mode: Use this mode when no
surround speakers are connected. This mode reproduces rear
sounds through the front speakers.
To select PHANTOM or 3 STEREO (3CH LOGIC)
Press DOLBY PRO LOGIC repeatedly until the desired DOLBY
PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode
is displayed cyclically as follows.
Г-- NORMAL-*- PHANTOM — 3 STEREO (3CH LOGIC) —i
■ cancel
To adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 of “ADJUSTING SPEAKER LEVEL
BALANCE”.
• Depending on the sound source and/or listening conditions, a
surround effect may not be obtained even when the Dolby Pro
Logic is on.
• The full DOLBY PRO LOGIC effect cannot be obtained when
using software without nnip°i.BYsuBRouwn| mark. In this case, use
the SURROUND system instead. (See page 12.)
• The DOLBY PRO LOGIC is automatically canceled when:
- the MIC or ECHO level is changed.
- the SURROUND system or the BBE is turned on.
- the headphones are plugged in.
- the Karaoke function is turned on.
- the 5.1 CH (page 35) is selected.
• Set the microphone volume to OFF while the DOLBY PRO
LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound can
not be reproduced correctly.
16
ENGLISH