Aiwa XR-MT1000 - Manual (Page 34)

GENERAL
ÌHB
Refer to the operating instructions of the connected equipment
for detaiis.
• The connecting cords are not supplied. Obtain the necessary
connecting cords.
• Consult your local Aiwa dealer for optional equipment.
5.1 CH INPUT JACKS
This MX-NMT1000 can input sound signals from the audio
equipment (DVD player, LD player, etc.) that contains a Dolby
Digital decorder with the 5.1 ch output terminals. Refer to
“CONNECTING A DVD PLAYER” on page 35.
CD DIGITAL OUT (OPTICAL) JACK
The DX-NM1000 can output CD digital sound signals through
this jack. Use an optical cable to connect digital audio equipment
(DAT deck, MD recorder, etc.).
Remove the dust cap @ from CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to CD DIGITAL OUT
(OPTICAL) jack.
When CD DIGITAL OUT (OPTICAL) jack is not being used
Attach the supplied dust cap (a).
VIDEO/AUX JACKS
The MX-NMT1000 can input analog sound signals through these
jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, MD players, VCRs, TV, etc.).
Connect the red plug to VIDEO/AUX R jack, and the white plug
to VIDEO/AUX L jack.
When connecting a tumtabie
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
MD JACKS
It is recommended that this jack be used to connect an MD player.
Use a cable with RCA phono plugs.
Connect the red plug to MD R jack of the MX-NMT1000, and the
white plug to MD L jack.
LINE OUT JACKS
The MX-NMT1000 can output analog sound signals through
these jacks.
Use a cable with RCA phono plugs to connect audio equipment
with LINE IN (analog input) jacks.
Connect the red plug of a cable to LINE OUT R Jack, and the
white plug to LINE OUT L jack.
Do not connect any equipment to LINE OUT jacks and VIDEO/
AUX jacks simultaneously. Otherwise, noise is generated and
malfunction occurs.
SUB WOOFER JACKS
Connect optional powered sub woofers with built-in amplifier to
SUB WOOFER jacks of the MX-NMT1000.
LISTENING TO EXTERNAL SOURCES
To play equipment connected to VIDEO/AUX jacks or MD jacks
proceed as follows.
1 Press VIDEO/AUX/5.1CH or MD.
To Play the equipment connected to VIDEO/AUX. press
VIDEO/AUX/5.1CH. “VIDEO” appears on the display.
To play the equipment connected to MD. press MD. “MD”
appears on the display.
2 Play the connected equipment.
To change a source name in the display
When VIDEO/AUX/5.1CH is pressed, “VIDEO” is displayed
initially. It can be changed to “AUX” or “TV”.
With the power on, press POWER while pressing VIDEO/AUX/
5.1CH.
Repeat the procedure to select one of the names.
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as follows.
1 Press VIDEO/AUX or MD and play the equipment.
2 Press N/ or so that the sound level becomes the same
as that of the other function sources.
During recording, the sound level can not be adjusted.
34
ENGLISH