Aiwa XR-MT1000 - Manual (Page 35)

LISTENING TO DOLBY DIGITAL
SURROUND SOUND
5.1 CH INPUT jacks of the MX-NMT1000 support the DOLBY
DIGITAL SURROUND system.
Connect a DVD player with 5.1 CH output jacks to this unit using
cables with RCA phono plugs as follows;
DVD player’s jack This unit’s jack
5.1CH OUTPUT FRONT (L,R), etc. ■
5.1
CH OUTPUT SURROUND (L,R), etc. ■
5.1 CH OUTPUT CENTER, etc. ■
5.1 CH OUTPUT SUB WOOEER, etc.-
LINE OUT (L,R), etc. ■
5.1CH FRONT (L,R)
5.1 CH SURROUND (L,R)
5.1CH CENTER
5.1CH SUBWOOFER
VIDEO/AUX
' If the DVD player Is not connected to VIDEO/AUX jacks of this
unit;
- the spectrum analyzer dose not show the sound level of the
DVD player.
- the sound from the connected DVD player cannot be recorded.
To remove these limitations, connect the LINE OUT jacks of
the DVD player to VIDEO/AUX jacks of this unit besides
connecting to 5.1 CH INPUT jacks. The signals through VIDEO/
AUX jacks enable the spectrum analyzer to work and the
recording to be done.
Refer also to the operating Instructions of the DVD player.
' DOLBY DIGITAL SURROUND sound cannot be recorded in
any way.
MANUAL
SELECT
DOWN,
UP
When a DVD player is connected to the 5.1 CH INPUT jacks of
the MX-NMT1000, you can listen to DOLBY DIGITAL
SURROUND sound, which enables you to enjoy theater-quality
sound in your home.
1 Press VIDEO/AUX/5.1CH repeatedly until “5.1 ch
IN” is displayed.
2 Start playing DOLBY DIGITAL SURROUND sound
on the DVD player.
•The DOLBY PRO LOGIC, BBE and the SURROUND are
automatically canceled when the 5.1 CH is selected.
• Make sure the software played back with the connected DVD
player support the DOLBY DIGITAL SURROUND
• The function is changed from the 5.1 CH to the VIDEO when;
- the headphones are plugged in.
- the MIC or ECHO level is changed.
- the Rhythm play function, the SURROUND system, the
DOLBY PRO LOGIC or the Karaoke function is turned on.
To adjust the sound levels of the center and surround
speakers in DOLBY DIGITAL SURROUND
1 Press VIDEO/AUX/5.1CH repeatedly until “5.1 ch IN” is
displayed.
2 Press MANUAL SELECT (TEST) repeatedly.
Speaker names appear in turn as follows;
L>R (Speaker balance)------- ► CEN; Center speaker -
<
a
Ш
z
Ш
о
-S-R; Right surround speaker-^ S-L: Left surround speaker-t
Press DOWN or ►► UP to adjust the sound level while
“CEN”, “S-L” or “S-R” is displayed.
Each level can be adjusted between -8 dB and +7 dB.
Repeat steps 2 and 3 to adjust each speaker’s sound level.
If the surround speakers or the center speaker level of the DOLBY
DIGITAL SURROUND is changed, that of the SURROUND
system (page 12) and the DOLBY PRO LOGIC (page 15) is also
changed.
ENGLISH
35