Geeneral there is no sound, Stereo receiver, Cassette deck the tape does not run – Aiwa XR-MT1000 User Manual
Page 37: Cd player
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GEENERAL
There is no sound.
• Is the AC cord connected properly?
• Is there a bad connection? (-► page 5, 6)
• There may be a short circuit in the speaker terminals.
Disconnect the AC cord, then correct the speaker
connections.
• Was an incorrect function button pressed?
Sound is emitted from one speaker oniy.
• Is the other speaker disconnected?
The output sound is not stereo.
• Is the Karaoke function turned on? (-» page 23)
An erroneous display or a malfunction occurs.
-■» Reset the unit. See “To reset”.
STEREO RECEIVER
There is constant, wave-like static.
• Is the antenna connected properly? (-> page 6, 7)
• Is the signal weak?
-■» Connect an outdoor antenna.
The reception contains noise interferences or the sound
is distorted.
• Is the system picking up external noise or multipath distortion?
-■» Change the orientation of the antenna.
Move the unit away from other electrical appliances.
To reset
If an unusual condition occurs in the display windows or the
cassette decks, reset the unit as follows.
1 Press POWER to turn off the power.
2 Press POWER to turn the power back on while pressing
SET. Everything stored in memory after purchase is
canceled.
If the power cannot be turned off in step 1 because of a
malfunction, disconnect the AC cord. Then connect it again
and carry out step 2.
POWER
CASSETTE DECK
The tape does not run.
• Is deck in pause mode? (-♦ page 29)
The sound is off-balance or not adequately high.
• Is the playback head dirty? (-» page 36)
Recording is not possible.
• Is the erasure prevention tab on the tape broken off? (-> page
30)
• Is the recording head dirty? (-» page 36)
Erasure is not possible.
• Is the erasure head dirty? (-* page 36)
• Is a metal tape being used?
High frequency sound is not emitted.
• Is the recording/playback head dirty? (-> page 36)
• Is a tape recorded without Dolby NR played back with the Dolby
NR system operating? (-* page 29)
<
DC
U
Z
111
o
CD PLAYER
The CD player does not play.
• Is the disc correctly placed? (-» page 24)
• Is the disc dirty? (-► page 36)
• Is the lens affected by condensation?
“► Wait approximately one hour and try again.
ENGLISH
37