Aiwa XR-MT1000 - Manual (Page 29)

PLAYING BACK A TAPE MUSIC SENSOR
IMS
Press DOLBY NR and turn Dolby NR on or off to
match the playback tape.
□□NR
I
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
Press ¡◄◄MS or ►►IMS during playback referring to the
playback side indicator (◄ or ►) on the display.
For example, when ►►IMS is pressed while ► is displayed,
playback of the next track starts.
The music sensor function may not be able to detect tracks under
the following conditions:
• Blanks of less than 4 seconds between tracks
• Noisy blanks
• Long passages of low-end sound
• Low overall recording levels
For tapes recorded with DOLBY NR, turn on □□ NR.
For tapes recorded without DOLBY NR, turn off □□ NR.
2 Press ◄►PLAY/DIR to start play.
Deck number playing
I
"Playback side indicator
■...............■ 7^
/ /■■■■ .1.
The tape counter indicates the tape running length.
"Playback side indicator
!►: The front side is being played (forward).
◄ : The back side is being played (reverse).
To begin play with the remote control
Press TAPE on the stereo receiver or on the remote control
first. Then, press PLAY on the remote control to start
play.
When tapes are loaded in both decks
Press TAPE first to select a deck.
The selected deck number is displayed.
To stop play, press BSTOP (or BCLEAR on the remote control).
To pause play, press IIPAUSE (or IISET on the remote control).
To resume play, press again.
To change the playback side, press ◄►PLAY/DIR in play or
pause mode.
To last forward or rewind, press ◄◄ MS or ►►MS. Then press
■ STOP (or ■ CLEAR on the remote control) to stop the tape.
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1 Insert tapes into deck 1 and deck 2.
2 Press TAPE on the stereo receiver to select the
deck to be played back first.
3 Press REV MODE to select Z).
4 Press ◄►PLAY/DIR to start playback.
Playback continues until ISTOP is pressed.
Ü
u
Q
u
I­
l"
u
M
M
o
To start play when the power is off (Direct Play Function)
Press TAPE on the stereo receiver. The power Is turned on and
play of the inserted tape begins.
To set the tape counter to 0000
Press BSTOP (or BCLEAR on the remote control) in stop mode.
The counter is also set to 0000 when the cassette holder is
opened and closed.
ENGLISH
29