To unplug the connector of the flat cable, Connecting an outdoor antenna, Remote contro – Aiwa XR-MT1000 User Manual
Page 7: Inserting batteries, When to replace the batteries, Using the remote controi
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To unplug the connector of the flat cable
Press the tabs and pull out.
CONNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an outdoor antenna is
recommended.
Connect the outdoor antenna to FM 75 Q. terminals.
REMOTE CONTRO
1
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
z
o
H
<
a
<
Q.
lU
■ |g-
a
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote controi
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
To connect other optional equipment -► page 34.
• If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
ENGLISH
7