ADLINK PXI-2022 - Manual (Page 22)

14 Getting Started
2.4 Installing the module
To install the PXI-2020/2022 module:
1. Turn off the PXI system/chassis and disconnect the
power plug from the power source.
2. Align the module’s edge with the card guide in the PXI
chassis.
3. Slide the module into the chassis, until resistance is felt
from the PXI connector.
4. Push the ejector upwards and fully insert the module into
the chassis.
5. Once inserted, a “click” can be heard from the ejector
latch.
6. Tighten the screw on the front panel.
7. Power on the PXI system/chassis.
To remove the module, reverse step 2 through 6 above.