AMT Datasouth M7 - Manual (Page 37)

Page of 73 37
Cutter Batch Cut the label once at the end of the printing job.
Note: If printing from enclosed software/driver, the software/driver will send
out the command, which will overwrite the setting set from the front
panel.
3.1.1.5 Offset:
This option is used to fine tune media stop location. Press the
button to
move the cursor from left digit to right digit, and press the button to set the
value from “+” to “-” or “0” to “9”. Press the button to set the value into
printer. Press key to cancel the setting and return to the previous menu.
The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send
out the OFFSET command, which will overwrite the setting set from the
front panel.
3.1.1.6 Shift X & Shift Y:
This option is used to fine tune print position. Press the
button to move the
cursor from left digit to right digit, and press the button to set the value from
“+” to “-” or “0” to “9”. Press the button to set the value into printer. Press
key to cancel the setting and return to the previous menu. The default
value is +000.
Note: If printing from enclosed software/driver, the software/driver will send
out the SHIFT command, which will overwrite the setting set from the
front panel.
Print Setup 5/12
Direction
Print Mode
> Offset
Offset
+000
Print Setup 7/12
Offset
Shift X
> Shift Y
Shift Y
+000