AMT Datasouth M7 - Manual (Page 42)

Page of 73 42
A. Gap Mode
Press the and buttons to scroll the cursor to the media type and press
the button to enter the sensor calibration mode.
Note: If printing from enclosed software/driver, the software/driver will send
out the GAP or BLINE command, which will overwrite the sensor type
setting set from the front panel.
A-1 Automatic
When enter the [Automatic] option, you will see following message, and printer
will feed 2 to 3 gap labels to calibrate the sensor sensitivity automatically.
When calibration is completed, the LCD screen will return to the previous
menu.
A-2 Manual
In case “Automatic” sensor calibration cannot apply to the media, please use
“Manual” function to calibrate the gap sensor manually.
When enter [Manual] option, you will see following message. Please complete
there steps
Paper Len.
00812 dot
1. Press the button to move the cursor
from left digit to right digit, and press the
button to set the value from “0” to “9” and the
“dot/ mm/ inch”. Press the
button to set
the paper length into the printer.
Calibration 1/4
> Gap Mode
Bline Mode
Cont. Mode
Gap Mode 1/4
> Automatic
Manual
Pre-Printed
Gap Mode
Automatic
Gap Mode 2/4
Automatic
> Manual
Pre-Printed