AMT Datasouth M7 - Manual (Page 45)

Page of 73 45
B. Bline Mode
Press the and buttons to scroll the cursor to the sensor type. Press the
button to enter the black-mark sensor calibration mode.
B-1 Automatic
When enter the [Automatic] option, you will see following message and printer
will feed the black mark label to calibrate the sensor sensitivity automatically.
When calibration process is completed, the LCD screen will return to the
previous menu.
B-2 Manual
In case “Automatic” sensor calibration cannot apply to the media, please use
“Manual” function to calibrate the bline sensor manually.
When enter [Manual] option, you will see following message. Please complete
there steps
Paper Len.
00151 dot
1. Press the button to move the cursor
From left digit to right digit, and press the
button to set the value from “0” to “9” and the “dot/
mm/ inch”. Press the
button to set the
paper length into the printer.
Bline Size
0024 dot
2. Press the button to move the cursor
From left digit to right digit, and press the
button to set the value from “0” to “9” and the “dot/
mm/ inch”. Press the
button to set the
bline size into the printer.
Calibration 2/4
Gap Mode
> Bline Mode
Cont. Mode
Bline Mode 1/4
> Automatic
Manual
Pre-Printed
Bline Mode
Automatic
Bline Mode 2/4
Automatic
> Manual
Pre-Printed