AMT Datasouth M7 - Manual (Page 44)

Page of 73 44
When enter [Pre-Printed] option, you will see following message. Please
complete there steps
Paper Len.
00812 dot
1. Press the button to move the cursor from
left digit to right digit, and press the button to set
the value from “0” to “9” and the “dot/ mm/ inch”. Press the
button to set the paper length into the printer.
Gap Size
0024 dot
2. Press the button to move the cursor from left
digit to right digit, and press the button to set the
value from “0” to “9” and the “dot/ mm/ inch”. Press the
button to set the gap size into the printer.
Gap Mode
Pre-Printe
3. Then, printer will feed labels to calibrate the sensor
sensitivity automatically. When calibration is completed, the
LCD screen will return to the previous menu.
Gap Mode 3/4
Manual
> Pre-Printed
Exit