AMT Datasouth M7 - Manual (Page 46)

Page of 73 46
Bline Mode
Scan Mark
Intensity
Ref. Level xxx
3. Open the print head mechanism, put the black
Mark under the media sensor. Press the
button to set the value into the printer.
Bline Mode
Scan Paper
Intensity
Ref. Level xxx
4. Then, put the label without black mark under the
media sensor. Press the
button to set the
value into the printer.
Note:
Normally, the value of “Ref. Level” for mark should be larger than paper for over 128.
If the media sensor fails to do so, you have to manually change the Intensity by
pressing
and to reach the above value.
Bline Mode
Complete
Intensity
Ref. Level xxx
5. The bline sensor calibration is complete. Press
The
button the LCD screen will return
to the previous menu.
Media sensor
Black mark
Media sensor
Label without
black mark