Ditch Witch 410SX - Manual (Page 111)

Service - 110
410sx Operator’s Manual
As Needed
Check Digging Chain Teeth and Bits
Check teeth (1) for wear every 10 hours. Replace
worn teeth, using Ditch Witch replacement parts
and maintaining original tooth pattern.
Check chain every 10 hours. Replace worn or
broken chains. If sidebars (2) are bent or loose on
chain pins (3), chain spacers should be used to
join sidebars.
For more efficient digging, contact your Ditch Witch
dealer for information about the tooth pattern best
suited to your jobsite.
Replace Digging Chain
Visually check digging chains for wear on rollers
and sidebars (2). Check pins (3) and bushing wear
by measuring distance between chain pins and
comparing it with a new chain. Also check digging
teeth (1).
IMPORTANT: If using rock chain bits, check that bits rotate freely. Clean chain and check bits after each
use. Replace bit when carbide cap or insert is worn or adapter can be damaged.
IMPORTANT: Replace sprockets when a new
chain is installed.
t39om021w.eps
t39om022w.eps