Drive, Shut down, 410sx operator’s manual – Ditch Witch 410SX User Manual
Page 46
410sx Operator’s Manual
Drive - 45
Shut Down
CMW
Drive
1.
Raise attachments for ground clearance. Ensure that plow swing lock is engaged.
2.
Check that tires are positioned straight or in direction of intended movement.
3.
Release parking brake.
4.
Press and hold operator presence switch.
5.
Move ground drive control in desired direction of travel.
6.
Adjust throttle for desired speed of travel.
Shut Down
1.
When job is complete, move ground drive control to neutral.
2.
Return all controls to neutral or disengaged position.
3.
Engage parking brake.
4.
Lower all attachments to ground.
5.
Move throttle to low idle for 2-3 minutes to cool.
6.
Turn ignition switch to OFF position. If leaving machine unattended, remove key.
7.
For maintenance or long-term storage, turn battery disconnect switch, if equipped, to the disconnect
position.
Tipover possible. Machine can tip over and crush you.
To help avoid injury:
• Always operate so that operator is on uphill side of machine.
• Keep digging boom low when operating or transporting on a slope.
• Never jerk control levers. Use a steady even motion.
• Drive slowly and cautiously at all times.
EMERGENCY SHUTDOWN: Turn ignition switch to STOP.
NOTICE: Machine should not be parked on a slope unless chocked, blocked, or parking brake
engaged.