Ditch Witch 410SX - Manual (Page 45)

Drive - 44
410sx Operator’s Manual
Start Unit
CMW
Start Unit
Before operating tractor, read engine manufacturer’s starting and operating instructions. Follow
instructions for new engine break-in.
1. Move all controls and switches to the neutral or disengaged position.
2. Verify that parking brake is engaged.
3. Insert key into ignition switch and turn to the ON position.
4. Verify that check engine light (engine malfunction indicator) is on.
5. Set throttle at low idle.
6. Turn ignition switch to START position. Release key when engine starts.
7. Verify that check engine light (engine malfunction indicator light) is off. If not, stop engine by turning
ignition switch to OFF position. Check for cause of engine malfunction.
8. Run engine at half-throttle or less for five minutes before operating tractor. During warm-up, check that
all controls work properly.
Runaway possible. Machine could run over you or others. Learn how to
use all controls. Start and operate only from operator’s position.
Read operator’s manual. Know how to use all controls
before operating machine. When you see this sign on the machine or
in the manual, read it and use caution. Your safety is at stake.
To help avoid injury:
• Read operator’s manual before operating equipment. Follow instructions carefully. Contact your
Ditch Witch dealer for operation information or demonstration.
• Wear hard hat, safety glasses, and other protective equipment required by job. Do not wear jewelry
or loose clothing that can catch on controls.