Ditch Witch 410SX - Manual (Page 70)

410sx Operator’s Manual
Drill - 69
Drill
CMW
Drill
1. Move throttle control to low idle.
2. Start tractor’s engine.
3. Move lever forward to begin clockwise rotation. (See page 31 for attachment control information.)
4. Slowly advance tractor while maintaining clockwise rotation.
EMERGENCY SHUTDOWN: Release drilling control and turn ignition switch to OFF.
NOTICE:
• Drilling too quickly causes bit to drift off course and may bend drill rod. After bore path is
established, speed may be slightly increased.
• If drill rod starts to bend, stop forward movement of unit and back the unit slightly until rod
straightens. Do not drill with bent rod.
• If drill rod hits an obstruction, rotate drill string counterclockwise to back up slightly.