Ditch Witch 410SX - Manual (Page 61)

Plow - 60
410sx Operator’s Manual
Operation
CMW
Finish Plowing
1. When installation is complete, move ground drive control to the neutral position.
2. With vibrator running, lower throttle speed and raise plow to just below ground level.
3. Move plow vibrator control to OFF.
4. Engage plow swing lock.
5. Raise plow out of ground.
6. Engage parking brake.
7. Turn ignition switch to OFF and remove product from plow.
8. Start tractor and drive a short distance away from work site.
9. Shut down tractor. See page 45 for proper shutdown procedures.
NOTICE: Do not operate vibrator when plow is out of the ground. This will cause excessive
vibration and will cause rapid wear, and possible damage to the unit and product being
installed.