Dunkirk Q95M-200 Modulating Condensing Boiler - Manual (Page 23)

23
PARAMETER MODE
Press [MODE] button 1 time from Standby Mode.
Display shows Para until a key is
pressed
Para then displays Parameter and Current Status. 1 180
Press and Hold Key(s) in BLACK (1) Duration Result Display
[MODE] [STEP] [STORE] [+] [-] Tap
Step to next parameter (continue tapping
Step to
change to 1, 2, 3, or 4)
DHW Setting 1 140
[MODE] [STEP] [STORE] [+] [-]
Tap Increase setting
DHW Setup 2 01
Hold FAST increase setting
[MODE] [STEP] [STORE] [+] [-]
Tap Decrease setting Space Heating Setup 3 01
Hold FAST Decrease setting
Outlet Temperature 4 190
[MODE] [STEP] [STORE] [+] [-] Tap
Store current setting (tap this key after
setting the parameter as desired) (See details below)
[MODE] [STEP] [STORE] [+] [-] Tap Next mode (info) Info
DHW Setting: Left digit
shows “1” and right
digit shows “140.” DO
NOT change this setting.
Performance could be
unreliable. Set DHW tank
temp. on DHW aquastat.
DHW Setup: Left digit shows “2”
and right digit should show “01.”
DO NOT change this setting. DHW
performance could be unreliable
or unsafe.
Space Heating (SH)
Setup: Left digit shows
“3” and right digit should
show “01.” DO NOT
change this setting as it
might affect performance
of your boiler.
SH Temperature: Left digit shows “4”
and right three digits show target outlet
water temp. (at 32°F outside if outdoor
sensor is used). Adjust to desired
settings with + and - keys.
(1) After the [STORE] button is pressed, the set value will flash twice to confirm the change. Change will take effect after you leave
Parameter Mode.
10 - USER INTERFACE QUICK REFERENCE