EXFO MaxTester MAX-610 - Manual (Page 205)

Frequency Tests
MaxTester Copper Test 197
TX/RX Tone
TX/RX Tone
The TX/RX Tone tests allow you to measure the frequencies and levels of
outgoing and incoming signals.
Send Tone
The Send Tone (TX) pane allows you to configure and
transmit a tone to a downstream device in the loop.

Current Group is the current test group name, for
example Frequency Tests.

Current Test displays the test being measured.
Here you can switch to another frequency test
from the given list. However, this action will
terminate the ongoing measurement test.

Send Tone allows you to select either a VF (voice
frequency) or WB (wideband) signal (if this option
was purchased).

Level allows you to set the tone level value.

Level Step (read only) displays the level step of the uplink frequency.

Frequency allows you to set a frequency value for the transmitting
tone.

Frequency Step lists a choice of frequency step values.

Termination Resistance lists a resistance value for the termination of
the Send Tone.

Result displays the values for both the TX VF/WB Level and
VF/WB Frequency.

Test Status displays the current state of measurement or an error
message.