EXFO MaxTester MAX-610 - Manual (Page 210)

TDR
202 MAX-610
Continuous

Pulse Width is a non-editable value that is updated dependent on
whether the parameters are set to Auto or manual.

Dual Trace Offset is a configurable offset parameter for the secondary
trace, with a range of -1.0 to 1.0.
Note: If the loaded secondary trace offset = 0, then the primary and secondary
traces will overlap.

Cable Setup button opens a new page that allows you to set the Cable
Parameters for the Current Test.

Select Graph button changes to Graph Selected when pressed and
opens a new selection of function keys which allow you to maneuver
the graph as follows:

Cursor - press the left/right arrow keys to decrease/increase the
values by moving the cursor. Press and hold the left/right arrow
keys to accelerate the cursor. Press
to recall the cursor and
place it in the middle of the current x-axis limits.

Zoom references the middle of the x/y axis and not the cursor
position. Press the arrow keys as follows:
Right = x-axis zoom in.
Left = x-axis zoom out.
Up = y-axis zoom in.
Down = y-axis zoom out.

Pan - use left/right arrow keys to pan the x-axis and the up/down
arrow keys to pan the y-axis.

1:1 resets the x-axis and y-axis limits to full scale.

Return To Test removes these function keys and displays the
previous ones.

Result displays the distance to the most significant reflection in text
and graphical measurements.