Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series User Manual
Page 11
Labconco Glassware Washer Service/Technical Manual
5
Inlet Solenoid
Valves
(Blue) Top
(rear)
Left
Electrically controlled to
allow water to fill the tank
of the machine.
DI/Pure Water Pump (Pink)
Bottom(front)
Left
Integrated pump to allow the
use of a non-pressurized Pure
water source.
Wash Pump/Motor
(Yellow)
Top (rear)
Right
The pump has been moved away
from the sump in order to
minimize the occurrences of
motors being damaged by
leaks.
Drain Pump &
Solenoid
(Red) Bottom(front)
Right &
Center
When the machine sets to
drain, the Solenoid will
“pop” open, three seconds
later the drain pump will
kick on and the water will
leave the tank.
Drying Blower
(Light
Green)
Left Center
The blowers are different
between the FlaskScrubber®
and SteamScrubber®. These
blowers circulate air through
the tank to dry labware after
it has been washed.
Overflow Sensor
(Dark
Green)
Top (rear)
Center
This sensor is a set of
contacts that when wet have
continuity, signaling the
washer that there is water in
the base weldment pan.
FlaskScrubber®
SteamScrubber®
These illustrations are to be compared with the photos on the previous page
and are in the same orientation with the colored circles representing the
same parts. The Purple Circle in the middle represents the Pump Outlet
Elbow.