Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 21)

Labconco Glassware Washer Service/Technical Manual
15
* To synchronize the travel of the slides, attach the upper rack and pull it
all the way out gently. Pull the rack out firmly several times to the
maximum travel length. When you push the rack in, the door should close
easily and latch smoothly.
Washing Tall Glassware / Removing Upper Rack
When the Upper Rack is in place, it limits the height of the glassware that
can be washed. If very tall glassware or long pipets are to be washed,
remove the Upper Rack.
1. Slide the upper rack all the way out of the washer.
2. Grasp each side of the rack, placing a thumb on the release buttons of
the rack clips.
3. Press each release button and lift the rack straight upward.
Adjusting the Height of the Upper Rack
1. Remove the upper rack as described above.
2. Remove the 2 nuts that retain the rack mounting plate to the slide.
3. Reposition the rack mounting plate to the slide using the other set of
holes. Replace 2 nuts.
4. Repeat the procedure on the opposite slide.
Making Adjustments to the Spindle Rack
Modification of the Spindle Rack can be done through optional accessories
that will customize the washer for each customer. These accessories include
two Pipet Inserts, an upper (spindle) rack, and varying size spindles.
Installing Optional Inserts into the Spindle Rack
A multi-Pin insert is available that can be placed directly on the spindle
racks. It can hold beakers or wide mouth glassware. The insert can be
positioned either on the left side or right side.
To install an insert:
1. Remove all glassware, spring retainers and glassware holders.
2. Lower the insert down over the spindles, if necessary, spindles may be
removed using the tool supplied with the Spindle Rack or a screwdriver
in the slot on the top of the spindles. Be sure to replace any removed
spindle with a plug supplied.