Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 8)

Labconco Glassware Washer Service/Technical Manual
2
are additional program selections that will be shown on the display if the
▼ button is pressed. If an arrow is visible in the upper right corner of
the display, additional program selections will be displayed when the ▲
button is pressed.
5. Press RUN if no modifications to the program are necessary.
6. If modifications to the program are necessary or you want to see the
parameters that are entered into the program, press DISPLAY and the
elements in the program that may be altered will be displayed.
7. Press the ▲ and ▼ buttons to select the parameter that must be altered as
indicated by the arrow on the left side. Press ◄ and ► buttons to select
the appropriate set point. The arrow on the lower right side means that
there are additional parameter selections that will be shown on the
display if the ▼ button is pressed. If an arrow is visible in the upper
right corner of the display, additional parameter selections will be
displayed when the ▲ button is pressed.
8. Press RUN when all parameters are satisfactory.
The most helpful menu when performing service or after doing a part
replacement is the DIAGNOSTIC MENU.
Diagnostics Menu
To ensure your washer is operating properly, perform the diagnostics
procedure detailed below. It will take approximately 10 minutes to complete.
Refer to the figure below to familiarize yourself with the control panel
before you begin the procedure.