Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 65)

Labconco Glassware Washer Service/Technical Manual
59
Baffle Gasket
Remove the damaged gasket (fig 2D) by pulling it from its housing at the
tank’s baffle (fig 3H). The unit may or may not have clips holding the two
gaskets into place (fig 1B). If it DOES, then those clips will need to be
removed, saved, and reinstalled when the new gasket is put into place.
1. Remove the clips and the silicon holding the gasket into place at the
baffle/water deflector.
2. Slide the gasket out of its fitting along the front side of the washer
and install the new gasket.
3. Replace the clips and use RTV Silicon to seat and seal the gasket into
place.
Figure 34
Above Left: Baffle Gasket and Clip. D) The baffle gasket seated in its housing. E) The original gasket can be removed after the clips
holding it are taken out of the baffle.
Above Right: Baffle, Gasket Clip & RTV. F) RTV seals the outer edge of the baffle gasket to the interior of the tank, must be removed
and reapplied when replacing the baffle gasket. G) Both the Clips must be removed and reinserted to hold the gasket into place. H) The
baffle weldment deflects water and holds the gasket in place.