Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 25)

Labconco Glassware Washer Service/Technical Manual
19
7. Remove the lower panel and the electrical junction box cover as
described in Removing the toe/kick panel.
8. Plug the supplied harness into terminal J6 on the Relay PCB and
route the other end to the left rear corner of the washer base.
9. Plug the wire from the detergent container to the mating connector
in the new harness in the base of the washer.
10. Plug the connectors on the pump to the mating connectors in the new
harness in the base of the washer
11. Reinstall the Junction Box cover and lower paneling.
12. Reinstall the back panel if the washer is a FS model.
13. Turn on the electrical power.
Enable the liquid detergent dispenser:
1. Enter the washer set up screen on the display by holding the ▼ button
on the control panel and closing the door and sliding the door latch to
the right.
2. Press the ▼ button until the arrow on the left points to LIQ DETERGENT
OPT.
3. Press the ◄ or ► button to activate this accessory.
4. Press RUN to save all settings.
Using the liquid detergent dispenser:
1. Remove the cap from the container and remove the tube and level switch
assembly.
2. Fill the container with detergent or use a new bottle of Labconco
detergent and replace the tube and switch assembly and the cap.
3. There are two methods which can be followed for filling the system with
detergent
a. Run a wash cycle with no glassware in the washer. Set the
detergent dispense rate to 30 ml.
b. Run a diagnostics test. When the display window shows DETERGENT
PUMP, allow the pump to run for 30 seconds.
4. Program the quantity of detergent that will be dispensed by entering
the programming screen as described in Chapter 4: Using Your Dishwasher
of the User/Instructional Manual that came with your washer.