Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 39)

Labconco Glassware Washer Service/Technical Manual
33
2. Press and hold the ▼ button and close the handle of the washer by
sliding the door latch knob to the right. Hold for 5 seconds.
3. The display will show the SET UP screen.
4. The > on the left side will highlight VOLTAGE.
5. Press the ▼ button until the > highlights LIQ DETERGENT OPT
6. Press the ◄ or ► buttons to select “NO” and turn off the PC Boards
detergent level sensor.
7. When the machine is restarted for normal operation the Alarm(s) should
have been cleared.
DRAIN FAIL ALARM
This displays if water fails to completely drain during a normal drain
operation. Operation of the washer is cancelled at this time. The
alarm is silenced by opening the door.
Before undertaking these procedures please do the following
preliminary check. If you look in User’s Instructional Manual (pages
15 and 16), there are diagrams picturing how to plumb the drainage
lines. Make sure your unit is set up according to the manual and no
extra length of tubing has been added to what is supplied by Labconco.
BEFORE CALLING FOR SERVICE, DETERMINE THE FOLLOWING:
PCBoard logic revision on the display when the latch is shut:
______________
Line voltage:
______________
Cycle and Segment running when the problem occurred:
Figure 5: (left)
Front view of
glassware washer.
Circle “4”
indicates location
of where the
Drain Pump can
be found (see
Figure 4)
Figure 6: (right)
Side view of
glassware washer.
Circle “3”
indicates location
of where the
Drain Valve &
Pump can be
easily seen/found
(see Figures 3 &
4).