Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 4)

Labconco Glassware Washer Service/Technical Manual
i
Introductory Note
The Labconco Glassware Washers were re-engineered in 2007, with the new line
available in September 2007. The new generation of Glassware Washers include
updated features and modifications that set itself apart from the previous
generations.
Some of these updates include (but are not limited to): an interactive
digital display, three separate pumps for wash, drain and pure water, a water
level pressure switch, and forced air blowers for drying.
The three types of Labconco Glassware Washers are, the FlaskScrubber®,
SteamScrubber®
, and FlaskScrubber® Vantage®. The FlaskScrubber® and
SteamScrubber® are available in either 115 or 230 (high-heat) Volt models,
and Under-Counter (UC) or Free-Standing (FS) configurations. An optional
viewing window is also available on these models.
The FlaskScrubber® and FlaskScrubber® Vantage® use a direct jet manifold
system for washing, rinsing and drying. They both include a Lower Spindle
Rack. The spindles on this rack can be swapped out with different sizes
(tall, short, and thin) or removed to create a flat rack.
The SteamScrubber® includes both an upper and lower open rack. The racks are
able to accommodate a wide variety of accessories to contain specific types
of lab-ware. Drying is performed through an integrated blower circulating
forced, heated air through the tank.
The FlaskScrubber® Vantage® sets itself apart from the rest as Labconco’s
sophisticated Laboratory Glassware Washer. It has the same basic setup as
the FlaskScrubber® and is available only as a high-heat 230V version. It
also has a built-in side cabinet that houses HEPA filtered forced air drying,
Liquid Detergent, and Acid Neutralizing Rinse Pump systems. A peristaltic
pump automatically draws a programmed amount of LabSolutions Liquid Detergent
or LabSolutions Neutralizing Acid Rinse for automatic dispensing during wash
cycles, and shelf for holding the two bottles of detergent and rinse aid.
This document serves to provide service technicians and users with
supplementary instructions for the care of their washer.