LINK Systems OmniLink II Press Automation Control - Manual (Page 102)

August 30, 2002 Manual Version 1.0 5.19
The display provides the following information:
1. A list of all jobs presently in the internal file storage. The jobs are identified by a 9 digit number, and
a 20 character description. A total of 500 jobs can be stored, and are shown in groups of up to 15.
2. The current job being used by the press control.
Job store, erase, and recall can be done only by persons having Key/Code access to Program Mode. If
code (password) access is used, the password user may be assigned permission to store, erase, and recall
as individual functions. A person might be allowed to recall a job, but not store or erase a job.
Section 5.6.1 Store Setup
From the Jobs Menu, Figure 5.9, pressing the STORE SETUP softkey will either transfer the screen to
the Store Jobs menu, or initiate the user password sequence which accesses the Store Jobs menu,
depending on the Key/Code Access Mode configured. The Store Jobs menu allows the user to place all
settings for the job currently in use into the internal file storage area. The menu shown in Figure 5.10
allows the user to enter a new number under which the job will be stored and a job description. Position
the cursor in the Job Number position. Then press the CHANGE NUMBER softkey. A nine digit
numeric number can be entered. This number must be unique to this job. Entering a number already in
use allows the current settings to replace the previous ones for that number. After entering a job
number, move the cursor to the Job Description position. Then press the CHANGE TEXT softkey. The
text edit box will appear and the name can be entered. Press the ENT key to save the name and exit the
text editor. Finally, press the STORE SETUP softkey. The current job information is placed in the
internal file system under the job number and job name. The operator terminal automatically returns to
the Jobs menu.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
PC STATUS
Counter OFF
STORE
JOBS
CHANGE
NUMBER
STORE
SETUP
0 0
PROGRAM/RUN SWITCH TOP
EXIT
Job Number 000000001
Job Description FIRST EXAMPLE
To Store a Job Setup:
1. Program all settings for the Limit Switch,
Tonnage Monitor, Die Protection, and Auto Setups
WARNING! Incorrect setups may cause damage and/or injury.
2. Enter the correct Job #.
3. Enter the Job description.
STORE SETUP when ready
Figure 5.10 Store Jobs Screen
NOTE: Changes made to the current job are NOT automatically made to the internal file system. If a
stored job is recalled, and changes are made to any settings, the user must intentionally Store the new
settings over the old job number before recalling another job if the changed settings are to be saved
permanently.