LINK Systems OmniLink II Press Automation Control - Manual (Page 137)

August 30, 2002 Manual Version 1.0 6.32
one time. The Reset can be configured to only reset the channels that are displayed on one Die
Protection screen. Eight channels are displayed on one Die Protection screen. The other configuration
is for the RESET ERROR softkey to reset all channels, those displayed and those not displayed.
Section 6.7.5 Status Information
Status information is available for the individual channel, the individual module, and the entire Die
Protection and Process Monitor system.
Individual channel status is listed next to the channel description on the Die Protection screen. Channel
status can be OK, Error, or Bypass.
Additional status information for the highlight channel is displayed at the bottom of the screen. This
will give specific information concerning the present status of the channel or the reason that an error
condition exists on this channel.
At the bottom of the screen are Module Status and System Status. The Module Status will display the
current status of the module that is selected for display. This System Status will display the current
status of all Die Protection and Process Monitor modules connected to the system.